THERMEx FJERNBETJENING Instrucciones De Uso página 57

THERMEX FJERNBETJENING 57
B R520192162008032018
will be deactivated. Periodical after-running will continue to be active however.
The remote control goes into standby if it isn't used for approx. 10 seconds. This is done to save
power in the remote control. The remote control is reactivated by pressing any button.
EXTRACTION
Press the after-running button to start the hood. The hood will always start at level 1. The hood
has a total of four levels that are selected by pressing the + and - buttons. The selected level is
shown in the display.
NOTE: If suction is activated and the extraction button is pressed, the suction speed will appear
in the display.
The motor is switched off by pressing on the - button until the display reads 0. The motor also
turns off if the remote control is turned off.
LIGHT
The light on the hood is turned on and off by pressing the light button. This can be done indepen-
dently of whether the motor is running or not.
NOTE: If the light is on and the light button is pressed, the selected brightness level will appear
in the display.
The light is always at full strength when switched on, but has four levels. The brightness of the
light is adjusted by pressing the + and - buttons. The light is switched off by pressing the - but-
ton until the display reads 0. The light also turns off if the remote control is turned off.
DECORATIVE LIGHT
NOTE: This only applies to the Metz Maxi Sky and Chamonix models.
All of the hood's functions must be deactivated in order to activate the decorative light. Only the
periodic room ventilation may be activated. Pressing the off button on the remote control turns
the hood off.
Keep the light button pressed for approx. three seconds until there is a "beep" sound from the
hood and the decoration light turns on. The decoration light is always white when switched on.