Dyna-Glo WBL100 Guia De Inicio Rapido

Cannot be used for garage and ice-house applications
NOTE: This accessory is required for safe operation when heater is floor mounted
Before installing Support Legs to
heater base, please make sure you
have the following items:
INSTALLATION OF SUPPORT LEGS
Support Leg
WARRANTY
If within one year from the date of original purchase, this item fails due to a defect in material or workmanship,
we will replace or repair at our option, free of charge. To order parts or to obtain warranty service,
call 1-877-447-4768, Monday - Friday, 8:30 a.m. - 4:30 p.m. CST. This warranty does not cover defects resulting
from improper or abnormal use, misuse, accident, or alteration. Failure to follow all instructions in the owner's
manual will also void this warrranty. The manufacturer will not be liable for incidental or consequential damages,
or common erosion of outdoor products. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
Support Leg
Screw
(M4*15) x 4
Support Leg
Screw
TO BE USED WITH ALL DYNA-GLO
If any part is missing or damaged, do not attempt to
assemble the product. Contact our Technical Service
Department at 1-877-477-4768 for replacement parts.
1. Set down a blanket onto the table where the
heater will be placed for leg installation to prevent
scratching of the table and/or the heater.
2. Set back of heater on table with the bottom of
heater extending outside the table edge.
3. Fasten Support Legs to heater using Support Leg
Screws.
1
DYNA-GLO
SUPPORT LEGS
MODEL # WBL100
WALL HEATER MODELS
Support Leg
x 2
IMWHL - 2018-4-24