Kohler K-527 Guia De Instalacion página 6

Apply sealant.
2. Install the Mounting Plate
Determine the interface installation location. The recommended mounting height is 54" (1372 mm)
from the floor to the bottom of the interface. Refer to the "Roughing-In" section.
Hold the mounting plate at the installation location and mark the center hole and two mounting
hole locations onto the wall.
Using a hole saw, cut a 1-3/8" (35 mm) hole in the finished wall at the marked location.
Using a 1/4" drill bit, drill holes at the remaining two marked locations.
Press the anchors into the wall.
Generously apply sealant in the groove on the back of the mounting plate.
Pull the cable through the finished wall and the center hole of the mounting plate.
Position the mounting plate on the wall with the tabs on top.
Secure the mounting plate to the wall with the screws.
Apply sealant to cover the mounting plate screws.
1143086-2-D
Finished Wall
1-3/8"
(35 mm) D.
Hole
Anchor
Tabs
6
Mounting Plate
Screw
Apply sealant.
Kohler Co.