Sleep Function - Tangent DUO Manual Del Usuario

1. TUNING: Turn the tuning knob to the right or to the left to change the
frequency range.
2. FREQUENCY SCALE: Shows both the AM and the FM frequency of the tuned
channel.
3. VOLUME: Turn the volume knob to the right to increase the volume or to
the left to decrease the volume of the speakers.This knob will also control
the volume of headphones when connected.
4. POWER LIGHT: Glows green when the unit is active.
5. TUNING INDICATOR: The tuning indicator will appear brightest when best
tuning has been achieved. Some weak, but listenable AM stations will not
light the tuning indicator and should be tuned for loudest and clearest
signal.
6. OFF/FM/AM/AUX: Turn the knob 1 click to the right to select the FM band, 2
clicks to the right to select the AM band and 3 clicks to the right to activate
the AUX input.Turn the knob all the way to the left to turn off the radio.
7. SLEEP FUNCTION: Press this button when the alarm has been set to listen to
FM or AM for approximately 20 minutes. After 20 minutes the radio will turn
off by it self.The sleep indicator will glow green when the function is
activated.
NOTE: the green sleep indicator will keep on glowing after the sleep
function has been performed. To turn the sleep indicator off, you must
push the sleep button once again.
8. SLEEP FUNCTION INDICATOR: Glows green when the sleep function is
activated.
9. ALARM ON/OFF INDICATOR: Glows green when the alarm is activated.
NOTE: The light is weak in the sleep and alarm indicators, in order not to
lighten up a dark sleeping-room
10. ALARM SWITCH: Sets the alarm on or off. Set the wakeup time to the
preferred time using the alarm thumbwheel. Select FM or AM and push the
alarm switch.The alarm indicator will start to glow green. When the
selected time is reached, the radio will start to play the selected station. If
the alarm switch is activated in OFF or AUX mode, the alarm will beep when
the selected time is reached.
NOTE: If the electricity goes out, the radio won't play, but you will hear the
alarm beaps.
11. CLOCK: Remember to check the battery annually so the clock stays
accurate.
12. CLOCK THUMBWHEEL: Rotate the thumbwheel counter clockwise until the
alarm hand points at the time you wish the alarm to start. Do NOT turn the
thumbwheel clockwise.This will damage the clock mechanism.
13. SNOOZE: (On top of the clock radio) Press this button during an alarm to
delay the alarm for 5 minutes.
NOTE: this can only be done 6 times. After that the alarm will not go on
again.
FRONT PANEL
05
UK