Max PowerLite AKHL1230ECE Manual De Funcionamiento Y Mantenimiento página 18

Compresor de alta presión
Tabla de contenido

Publicidad

WARNING
• You must observe the specified operating
air pressure for the nailers and pneumatic
tools.
Using a nailer or pneumatic tool without ad-
justing the supply pressure with the reduc-
tion valve can seriously degrade their
performance, induce their premature aging
or damage them.
• Using a nailer or pneumatic tool at an inappro-
priate pressure level (at an unnecessary high
pressure) increases their air consumption, po-
tentially degrading their capability in continu-
ous work. Be sure to use them at the
appropriate pressure.
hose
3. After you have finished with the adjust-
ment of supply pressure, you can start
the operation by connecting the air hose
to the air outlet (air chuck).
4. Connect the high pressure hose to the
high pressure air hose for MAX PowerLite
tools to the high pressure air chuck on
the H side of the pressure-reduction
valve.
Connect the air hose for the general-purpose
nailer to the air chuck on the L side of the
pressure-reduction valve.
• The air chuck is the one-touch type, allow-
ing you to connect the air plug to the air
chuck just by pushing in.
High pressure
air chuck
WARNING
• Before connecting the air hose to this com-
pressor, make sure that the air hose and
hose fixture are firmly secured.
5. OPERATION OUTPUT AUTOMATIC
SWITCHING MECHANISM
Operation mode switching on this machine is
carried out by the selector switch. Select a
desired mode from those listed in the table
on page 15 according to the given applica-
tion.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido