Drain Tank; Replacement Parts - Max PowerLite AKHL1230ECE Manual De Funcionamiento Y Mantenimiento

Compresor de alta presión
Tabla de contenido

Publicidad

23. DO NOT MODIFY THE COMPRESSOR
Do not modify the compressor. Always con-
tact the authorized service facility any re-
pairs. Unauthorized modification may not
only impair the compressor performance but
may also result in accident or injury to repair
personnel who do not have the required
knowledge and technical expertise to per-
form the repair operations correctly.
24. TURN OFF THE SWITCH WHEN THE
COMPRESSOR IS NOT USED
When the compressor is not used, turn the
switch OFF, disconnect the plug from the
power source and open the drain cock to dis-
charge the compressed air from the air tank.
25. NEVER TOUCH THE SURFACE OF THE
HIGH-TEMPERATURE SECTION
In order to prevent a burn, do not touch the
piping, head, cylinder, motor and inverter
case(lower cover).
26. DO NOT DIRECT AIR STREAM AT BODY
Risk of injury, do not direct compressed air at
persons or animals.

27. DRAIN TANK

Drain tank daily or after 4 hours of use.
Open drain cock and tilt compressor to emp-
ty accumulated water.
28. DO NOT STOP COMPRESSOR BY PULL-
ING OUT THE PLUG
Use the " ON/OFF " switch.
29. WHENEVER USING THE HIGH PRESSURE
SIDE OF THE MAX POWERLITE COMPRES-
SOR, THE GENUINE PARTS FOR THE MAX
POWERLITE TOOLS, POWERLITE HOSE
AND COMPRESSOR MUST BE USED.

30. REPLACEMENT PARTS

When servicing, use only MAX genuine
parts. Repair should be conducted only by
authorized service facility.
31. NEVER USE A TRANSFORMER FOR THE
POWER SUPPLY OF THIS COMPRESSOR.
USING A TRANSFORMER TO INCREASE
THE VOLTAGE WILL CAUSE A FAILURE OR
BURNOUT. (IF A TRANSFORMER IS USED,
OPERATION OF THE MACHINE WILL
STOP.)
7
OFF

Publicidad

Tabla de contenido
loading

Tabla de contenido