Getting Started - Watchguard FireBox X Edge 10e Guía Rápida

Getting Started

1
Register with LiveSecurity® Service
• Find and record your serial number.
• Go to http://www.watchguard.com/activate
• Log in.
(NOTE: If you are new to WatchGuard, follow the instructions to create a profile.)
• Follow the instructions on the screen.
• Copy your feature key to a text file. You will need it later.
2
Download software
• Continue and go to
https://www.watchguard.com/archive/softwarecenter.asp
• Download the latest Edge software.
• Record the name and location of the file you download.
Gather network information
3
Most Internet Service Providers (ISPs) give IP addresses to their
customers automatically through DHCP. Some providers use a static IP
address for each customer, or use PPPoE for authentication.
• If your ISP gives you an IP address automatically, go to Step 4.
• If your ISP gives you a static IP address or requires PPPoE
authentication, record your network information below.
Use the documentation from your ISP, or contact them for
more information.
TCP/IP Settings
IP Address __________________________________
Subnet Mask _______________________________
Default Gateway ____________________________
Primary DNS _______________________________
Secondary DNS _____________________________
DNS Suffix _________________________________
PPPoE Settings
Name ___________________________________
Domain __________________________________
Password __________________________________
4
Before you connect
• To connect to the Firebox® X Edge, you must configure the network
setting on your computer to use DHCP.*
• Make sure the proxy server setting is disabled in your web browser.
You cannot connect to the Firebox X Edge if you use a proxy server.*
• Make sure that your web browser is not set to block pop-up windows.
You cannot start the Quick Setup Wizard if you block pop-up windows.*
For more information, see "Setting Your Computer to Connect to the Edge" in Chapter 2 of the User Guide.
*
5
Connect cables and power cord
6
Run the Quick Setup Wizard
• Before you start the Quick Setup Wizard, make sure:
- You have registered your Firebox X Edge with LiveSecurity.
- Your computer is set to connect using DHCP.
• Start your web browser.
• Type https://192.168.111.1 in the address bar of your browser and
press Enter.
• Use the Quick Setup Wizard to configure your Firebox X Edge.
• Use the user name and password you set in the wizard to log in to
your Edge.
• To install the most current Edge software, run the executable file you
downloaded in Step 2.
Ethernet interfaces
Serial connector
Power connector
Reset button