STACK-ON GCG-8RTA Instrucciones página 2

Shelf
Locking nut
Machine
screw
Figure 3
Top panel
Figure 4
3.
Assemble the optional
storage shelf at this time. It
will be easier to align the
holes without the top on.
Use the top set of holes in
the side panels and assemble
the shelf with (4) machine
screws and locking nuts. (See
Figure 3)
4.
Assemble the top panel
(which has the name plate).
This will assemble the same as
the bottom panel.
With the front and back
flanges on the outside of the
cabinet and the side flanges on
the inside of the cabinet,
assemble with (10) carriage
bolts, lock washers and nylon
locking nuts. (See figure 4)
Now tighten all the fasteners
in the cabinet body. Do not
over tighten.
Door
Figure 5
Nut
Locking
washer
Figure 6
6.
Assemble the lock and ring
through the front of the door.
Secure the lock with the locking
washer and nut. (See figure 6)
5.
The door can be
assembled on the left or
right. Depending on where
you are going to place your
cabinet, you may want your
door to open in a certain
direction. Review the
section "Selecting a
Location" and determine the
opening direction before
assembling the door.
Align the door hinge holes
with the cabinet holes.
Assemble with (8) machine
screws and locking nuts.
(See figure 5)
Center the door in the
opening (from top to
bottom) and tighten the
screws.
Ring
Lock
2
18
4327-1309