Selecting A Location - STACK-ON GCG-8RTA Instrucciones

SELECTING A LOCATION

The cabinet must be mounted to wall studs and the floor. For
optimal safety and security, the cabinet should be installed adjacent
to the side wall of a closet with minimal space on either side of the
cabinet, in an isolated, dry and secure area. The cabinet should be
flat against the wall at the back of the unit, as well as flat on the floor.
Remove the baseboard if necessary.
THE CABINET SHOULD ALWAYS BE KEPT OUT OF
THE REACH OF CHILDREN.
CENTERS
CABINET
TOP VIEW
MINIMUM
16"
SECURING THE CABINET
NOTE: This cabinet must be mounted to wall studs and the
floor. Failure to do so will compromise the safety and security
of the cabinet.
NOTE: The cabinet must be secured to wall studs in the top holes
in the back of the cabinet so that it is anchored to the wall studs in
two locations. The cabinet must also be mounted to the floor. Use
the hardware provided or consult your hardware retailer for
fastening hardware for your particular mounting surfaces
Drill (2) 3/16" pilot holes into the wall studs lining up with the top
(2) mounting holes in the back of the cabinet. Secure the cabinet to
the wall using (2) lag bolts and washers.
Drill (2) pilot holes and secure the cabinet bottom to the floor with
(2) lag bolts and washers.
IMPORTANT
Keep keys away from children. Keep this record of your serial and key
numbers in a secure place separate from your security cabinet. If you lose your
keys you will need this information as a reference for obtaining new keys. To
order a replacement key set, follow the instructions on the attached form.
STACK-ON PRODUCTS COMPANY
P.O. BOX 489
WAUCONDA, IL 60084
4
18
4327-1309