Parts Identification; Filling The Water Tank - impress IM-12B Manual De Instrucciones

1. Spray nozzle
2. Water inlet
3. Steam control
4. SteamBurst button (IM-14G only)
5. Spray button
6. Temperature pilot light
7. Swivelling cord protector
8. Power cable
9. Water tank
10. Temperature control
11. Soleplate
12. Water measuring cup
• The iron must be used and rested on a stable surface.
only fill in water, no other liquids or additives!
• high temperatures develop at the soleplate (11) of
the steam iron which can cause serious burns. There-
fore, always take the appliance by its handle and warn
others (especially children) against possible hazards
(e.g. scalding from steam or hot water).
• never put the iron down on its soleplate (11) during
use. when placing the iron on its stand, ensure that
the surface on which the stand is placed is stable.
• always disconnect the power cable
- Before filling the water tank (9) or emptying it.
- when leaving the iron unattended (even for a short
time).
- Before cleaning.
- Immediately after use.
• do not use the iron when it leaks
• WARNING! Never iron clothes on the body!
BEfORE fIRST USE
If necessary, peal the protective foil off the soleplate
(11). Wipe the soleplate with a soft cloth
OPERATION

fIllING THE WATER TANk

Warning! Before filling the tank make sure the
iron is not plugged into the outlet. Always discon-
nect the power plug prior to filling.
In order to avoid clogging/scaling, we recommend

PARTS IdENTIfICATION

INSTRUCTIONS
using distilled or purified water only. you can use tap
water, but more frequent cleaning is advised.
• Set the steam control (4) to - (steam off).
• open the water inlet (2).
• Fill in water (no additives) up to the maximum fill-
ing mark indicated on the water tank (9).
• close the water inlet (2) again.
Please note: To prevent corrosion and spilling, we
recommend emptying the water tank (9) after use
CONNECTING TO POWER
• connect the power plug of the appliance to a prop-
erly installed and easily accessible wall socket. The
temperature pilot light (6) lights up while the iron
heats up. It goes out as soon as the iron reaches the
preset temperature. you may now start ironing.
• during ironing, the temperature pilot light (6) auto-
matically cycles on and off as the iron heats up and
cools down.
SETTING THE IRONING TEMPERATURE
Set the temperature control (10) according to the in-
ternational textile protection symbols (located on the
temperature control (10) and the washing label of the
garment).
• rayon, acrylic (low temperature)
•• Silk, wool (medium temperature)
••• cotton, linen (high temperature)
Pre-sort the garments if necessary.
English - 2