Panel Programming - Fermax LYNX SMILE Serie Manual De Instalador

Once in the preferred language, for the Audio Settings select Aspect >> Call Settings.

Panel PROGRAMMING

If for any reason you need to reprogram the panel, the operation required is to rest the
panel and restore the factory values and settings.
Reset to Factory Values
This is done through some electric operations on the equipment, so it would be impossible
for anyone without physical access to the equipment to carry out such modifi cations.
Steps:
1. Turn off the system power supply.
2. Short circuit the terminals 'BS' and '-' of the amplifi er.
If the system is equipped with an exit push button (BS, -), simply press and hold it.
3. Reconnect the system power supply and keep the short circuit (or press and hold the
exit push button), until a 'beep' sound is heard. From that moment on you can remove
the short circuit from the 'BS' and '-' terminals or release the push button.
After these steps are completed, the factory values and setting will have been restored
in the panel.
27
LYNX SMILE KIT