Palram Olympia 3x4.25 Manual Del Usuario página 8

IMPORTANT
Please read these instructions carefully before you start to assemble this product
.
Please
carry out the steps in the order set out
in
these instructions.
Keep these
instructions
in
a
safe place
for future
reference.
Safety advice
For
safety purposes we strongly recommend the product to
be
assembled by at least two people.
Be
sure
to check that there
are no hidden pipes or cables in
the wall before drilling.
Some parts may have sharp edges. Please be
careful when handling components. Always wear
gloves, eye
protection,
and long sleeves
when assembling or performing any maintenance
on
your product.
Do
not attempt to assemble the product
in
windy or wet conditions.
Do not
attempt to assemble the product if you
are tired, have taken drugs,
medications or alcohol, or if you
are
prone to dizzy spells.
Dispose
of
all plastic bags safely
-
keep
them
away
from children's
reach.
Keep children away from the assembly area.
When using
a
stepladder or power tools, make
sure
that you
are
following
the manufacturer's
safety advice.
Do
not climb or stand on the roof.
Do
not hang or
lay
on the profiles.
Heavy articles should not
be
leaned against the poles.
Keep
roof
and
gutters
clear
of
snow,
dirt
& leaves.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
If color was scratched
during
assembly it can be fixed.
Cleaning instructions
In
order to
clean the product,
use a
mild detergent solution and rinse
with
cold clean water.
Do
not
use
acetone, abrasive cleaners, or other
special
detergents to
clean
the
panels.
Clean the product once assembly
is
complete.
Before
starting
assembly
Choose your site carefully before beginning assembly.
The
ground
surface must be
perfectly flat
and leveled and have
a
solid base such
as
concrete, asphalt, deck etc.
Sort the parts and check against the content
parts list.
Parts
should
be
laid out close at hand. Keep
all
small parts (screws etc.) in
a
bowl
so
they
do not get
lost.
Please
consult your
local
authorities if
any permits are
required prior to constructing the
product.
Having purchased
a
long patio
cover, make sure
you received
all boxes
according
to the additional page (Extending your patio cover) on the instruction manual.
As
soon
as
you are ready to assemble your patio cover (you can start
with this
box), sort the parts and check against the content parts list.
Prior to enlarging the Patio Cover, several parts need to
be
dismantled, it
is
recommended to keep them
in
a
safe place
for future
use.
Note:
Use
only the parts registered
in
the content
list,
some parts may
be
surplus.
Tools &
Equipment
T001
(Supplied)
During Assembly
MWhen encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Note:
Anchoring this product to the ground
is
essential to
its
stability and rigidity.
It
is
required to complete this
stage in
order for your warranty to
be
valid.