JENN-AIR JGC8430 Guia Del Usuario página 6

Ocultar thumbs Ver también para JGC8430:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

U
Y
SING
OUR
C
OOKTOP AT A
G
LANCE
MODEL JGC8430
1 2
1. Left rear surface burner (10,500 BTUs).
2. Left front surface burner (6,500 BTUs
on Hi, 850 BTUs on Lo).
3. Right front surface burner (12,000
BTUs).
4. Right rear surface burner (9,100 BTUs).
MODEL JGC8645
1 2
3
4
1. Left rear surface burner (10,500 BTUs).
2. Left front surface burner (9,100 BTUs).
3. Center rear surface burner (6,500 BTUs
on Hi, 850 BTUs on Lo).
4. Center
front
surface
(6,500 BTUs on Hi, 850 BTUs on Lo).
5. Right front surface burner (12,000
BTUs).
6. Right rear surface burner (9,100 BTUs).
To prevent the cooktop from discol-
oring or staining:
Clean cooktop after each use.
Wipe acidic or sugary spills as soon
as the cooktop has cooled as these
spills may discolor the porcelain.
C
OOKTOP
S
EALED
The sealed burners of your cooktop are
secured to the cooktop and are not de-
signed to be removed. Since the burners
are sealed into the cooktop, boilovers or
spills will not seep underneath the cooktop.
However, the burner heads should be
cleaned after each use. The head portion of
the burner is easily removed for cleaning.
(See page 6 for cleaning directions.)
3 4
H
P
IGH
B
URNER
There is one high speed burner on your
cooktop, located in the right front position.
This burner offers higher speed cooking
that can be used to quickly bring water to a
boil and for large-quantity cooking.
S
IMMER
(850 BTU
This burner is located in the left front
position (JGC8430) or in the center posi-
5 6
NOTES:
A properly adjusted burner with clean ports will light within a few seconds. If using
natural gas, the flame will be blue with a deeper blue inner cone.
burner
If the burner flame is yellow or is noisy, the air/gas mixture may be incorrect. Contact
a service technician to adjust. (Adjustments are not covered by the warranty.)
With LP gas, some yellow tips on the flames are acceptable. This is normal and
adjustment is not necessary.
With some types of gas, you may hear a "popping" sound when the surface burner
is turned off. This is a normal operating sound of the burner.
To improve cooking efficiency and to prevent possible damage to the range or pan,
the flame must be adjusted so it does not extend beyond the edge of the pan.
,
.
CONT
B
URNERS
ERFORMANCE
(12,000 BTU
*)
S
B
URNER
*)
S
5
tions (JGC8645). The simmer burner offers
a lower BTU flame for delicate sauces or
melting chocolate.
* BTU ratings will vary when using LP gas.
B
G
URNER
RATES
The grates must be properly positioned
before cooking. Improper installation of
the grates may result in chipping of the
cooktop.
Do not operate the burners without a
pan on the grate. The grate's porce-
lain finish may chip without a pan to
absorb the heat from the burner
flame.
Although the burner grates are durable,
they will gradually lose their shine and/or
discolor, due to the high temperatures of
the gas flame.
4

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Jgc8645

Tabla de contenido