Operating Modes - Gabarron DILIGENS DIL4GC Instrucciones De Instalacion Y Uso

3. - USING THE THERMAL RADIATOR
Daily Programming:
Temperature level for each
time interval (1h) of the day.
Temperature setpoint.
Operating mode.
OK / Mode Key
Press the key to select operation
mode: Auto, Manual, Off, and to
set the value of the different
parameters.
3.1- ON/OFF
To connect the heater, switch on the switch on the back surface of the heater. Press the key Ok/Mode to change to Manual or
Auto mode and start the radiator.

3.2.- OPERATING MODES

Three different operation modes may be applied: Auto. Manual, Off. To switch from one to another press the OK/Mode key.
The LCD display in the different modes are shown in the next figure.
The heating element will begin operating when the ambient temperature is below the set temperature of the current mode, the
symbol is displayed on the LCD indicating that the heating element is operating. When the display only shows the setpoint
temperature and the symbol
ambient temperature is higher than current setpoint temperature.
is not displayed, the device is in operation, but the heating element is not working because
Main switch.
All models are
equipped with one
switch on the back
surface allowing the
heater disconnection.
G-Control Hub
connection indicator.
Heating on indicator.
Current set point
temperature in AUTO
mode.
Config / Prog Key
Press the key to programme and
configure the thermal radiator in
AUTO Mode.
13
EN