Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. - USING THE THERMAL RADIATOR
Daily Programming:
Temperature level for each
time interval (1h) of the day.
Temperature setpoint.
Operating mode.
BACKLIGHT
Pressing any button the display will illuminate with a soft white colour. After certain time if no buttons are pressed the display
backlight will turn off.
OPERATING MODES
Press
, the operation modes are displayed, with the selected one flashing. Use
mode. Confirm with
The heater has three different operation modes: Auto, Manual override and OFF.
3.1. ON/OFF
Once the heater is connected to a main supply you can turn the heater ON by switching the main ON/OFF switch positioned at
the rear right side of the heater as shown above.
OK / Mode Button
Press the button to select
operation mode: Auto, Manual,
Off, and to set the value of the
different parameters.
.
AUTO
Main switch.
All models are
equipped with one
switch on the back
surface allowing the
heater disconnection.
Config / Prog Button
Press the button to programme
and configure the thermal radiator
in AUTO Mode.
MANUAL override
12
G-Control Hub
connection indicator.
Heating on indicator.
Current set point
temperature in AUTO
mode.
or
to select the desired operation
OFF
Publicidad
Tabla de contenido
