Charging Usb Devices - Celestron POWERTANK LITHIUM LT Manual De Instrucciones

CHARGING USB DEVICES

Plug one end of the USB charging cable for the device you wish
to charge into the USB port on the PowerTank Lithium LT. Plug
the other end of the cable into your device. Press the power
button to begin charging. When you are done charging, press
and hold the power button to turn the power off. You can also
simply unplug your device's cable from the power pack, and it
will automatically turn off after one hour. The USB port provides
5V DC @ 2.1A output, so it is capable of "fast-charging" devices
that have this functionality.
POWERING TELESCOPES AND OTHER ELECTRONICS
PowerTank Lithium LT comes with a power cable that is
compatible with Celestron telescopes. It can also be used with
many other telescopes, telescope accessories, and electronics
that have a 5.5mm/2.1mm tip positive 12V DC power jack. The
cable has identical connectors; plug one end of the cable into
the power jack on your telescope and plug the other end into
the 12V DC port on the power pack. Press the power button to
activate power. Turn the power pack off by pressing and holding
the power button. Otherwise, the power pack will automatically
shut off after 1 hour when no load is detected.
The PowerTank Lithium LT is designed to supply a maximum of
3A. If the current draw is continuously greater than 3.2A, it will
immediately cut off the output. The battery indicator lights will
flash 10 times, then turn off. If a short circuit occurs, the power
pack will shut off immediately, and will need to be recharged
before it will turn on again.
I
4 ENGLISH