Price Pfister AMHERST 34 Serie Manual Del Usario página 2

Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price
Pfi ster recommends calling a professional if you are uncertain about installing
this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are
usually found under the sink or near the water meter. If you are replacing an
existing faucet, remove the faucet from the sink and clean the sink surface
thoroughly.
3
3 TOOLS RECOMMENDED
•Plumber's putty •Slotted screwdriver
•Adjustable wrench •Flashlight
Your installation may require new supply lines and / or shut-off valves or other
additional tools.
4 These instructions cover three
different installations
•Pliers
•Cloth
Models
34-4H
Option 1:
2 Hole With Single Post
Installation
Go To Step 5 Go To Step 5
Models
34-4H
Option 2:
4 Hole With Deckplate
Installation
Go To Step 8 Go To Step 8
Models
34-PH
3 Hole With Single Post
& Soap Dispenser
Installation
Go To Step 11 Go To Step 11
ENGLISH ENGLISH
2 HOLE WITH SINGLE POST INSTALLATION
5
5D
5 MOUNTING RING & GUIDE FLANGE INSTALLATION
Insert Hose Guide (5A) into Hose Guide Flange (5B) and onto sink hole. Place
Mounting Ring (5C) over Plastic Gasket (5D) and sink hole. If desired, place a
small bead of plumber's putty to underside of Hose Guide Flange (5B). Ensure
that Mounting Ring (5C) sits with Flats (5E) parallel with the outer sink hole.
6
6 SECURING HOSE GUIDE
From underneath sink, secure Hose Guide (6A) by screwing Plastic Locknut
(6B). Hand tighten. Caution: do not over-tighten.
7
7 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (7A) through Hose Guide (7B). From underneath sink,
feed Side Spray Hose (7A) back up through the center hole of sink and through
Mounting Ring (7C) so that it is above the sink.
2
INSTALLATION
5E
5C
6B
7C
7A
STOP Go To Step 15 Go To Step 15
5A
5B
6A
7B