Price Pfister AMHERST 34 Serie Manual Del Usario página 3

4 HOLE WITH DECKPLATE INSTALLATION
8
8A
BOTTOM GROVE
8 DECKPLATE INSTALLATION
Ensure that Plastic Putty Plate (8A) is pressed onto Deckplate (8B). Place a
bead of plumber's putty in the groove along the outer edge of Putty Plate (8A).
If desired, place a small bead of plumber's putty to the underside of Hose Guide
Flange (8D). Insert Hose Guide (8C) into Hose Guide Flange (8D) and onto
the sink hole. Install Deckplate (8B) over the holes in the sink.
9
9E
9D
9 SECURING DECKPLATE & HOSE GUIDE
From underneath sink, secure Hose Guide (9A) by screwing Plastic Locknut
(9B). Secure Deckplate (9C) by screwing Wing Nuts (9D) to Mounting Posts
(9E). Hand tighten. Caution: do not over-tighten. Remove any excess putty
from around the outside edge of Deckplate (9C).
10
10C
10A
10 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (10A) through Hose Guide (10B). From underneath
sink, feed Side Spray Hose (10A) back up through the center hole of sink and
through Deckplate (10C) so that it is above the sink.
STOP
8B
8C
8D
9A
9C
9B
10B
Go To Step 15 Go To Step 15
ENGLISH ENGLISH
3 HOLE WITH SINGLE POST & SOAP
DISPENSER INSTALLATION
11
11D
11 MOUNTING RING & GUIDE FLANGE & SOAP
DISPENSER SHANK INSTALLATION
Insert Hose Guide (11A) through Hose Guide Flange (11B), insert Soap Dispenser
Shank (11C) through Foam Gasket (11D) and place Mounting Ring (11E) over
Plastic Gasket (11F) and into the sink holes. If desired, place a small bead
of plumber's putty to the underside of Hose Guide Flange (11B). Ensure that
Mounting Ring (11E) sits with Flats (11G) parallel with the outer sink holes.
12
12B
12 SECURING HOSE GUIDE & SOAP DISPENSER SHANK
From underneath sink, secure Hose Guide (12A) and Soap Dispenser Shank
(12B) by screwing Plastic Locknuts (12C) and (12D). Hand tighten.
Caution: do not over-tighten.
13
13D
13B
13A
13 SOAP DISPENSER INSTALLATION
From underneath sink, thread on Bottle (13A) to Shank (13B). Pour in liquid
soap (not included) into Shank Orifi ce (13C). Insert Pump Mechanism (13D)
into soap dispenser body. Install Dispenser Head (13E) by pushing fi rmly onto
dispenser mechanism.
3
11C
11G
11F
12C
12D
13E
13C
11E
11A
11B
12A