Noblex NR 1000 Instrucciones Para El Uso página 14

II. Rain mode
In this mode, the direct distance of the device to the target object under
rain conditions is measured.
By means of this program, the disturbing raindrops that could falsify the
measurement result are eliminated.
III. Near distance "Golf mode" :
In this mode, the direct distance of the device to the near target object is
measured. This mode is used e.g. for golf activities. As long as the target
has been clearly recognized by the device, the symbol " " is displayed. If
the target is not uniquely detectable for the device, i.e. if several targets
are within the detection range, the distance to the closest target is mea-
sured. The symbol that is displayed by the device in this case is "
IV. Long distances "Hunting mode"
In this mode, the direct distance of the device to the more distant target
object is measured. Any partially disturbing foreground objects such as
bushes, stones and branches are ignored in this mode. If a clear target
has been targeted, the symbol "
unique to the device, i.e. if several targets are within the detection range,
the distance to the closest target is measured. The icon that is displayed
by the device in this case is " ".
BRIGHTNESS CONTROL OF THE DISPLAY
The rangefinder has a red OLED display and allows easy reading of the
results even on bright days. There are a total of 6 brightness levels that can
be selected. To adjust the brightness of the display, the full display mode
(V) must be activated. This mode is accessed by pressing the " " mode
button (D) repeatedly until all three mode symbols are displayed in the top
left corner of the field of view. The current illumination level appears in the
center of the field of view (VI). To switch between the brightness levels, the
switch-on " " button must be pressed. After the appropriate brightness has
been found, the mode button can be used to return to standard mode " "
and to continue measuring respectively to switch again to the desired mode.
UNITS OF MEASURE
With the rangefinder, you can choose between yard "Y" or meter "M" (3; 5).
To change the unit of measure of the distance display, the mode button " "
(D) should be pressed for approx. 2 seconds.
14
:
:
" will be displayed. If the target is not
".