Reconnecting; Pairing With Another Device; On / Off Switch; Pairing A Second Bluetooth Device - Marmitek BoomBoom 55 Modo De Empleo

6.3

Reconnecting

If the BoomBoom 55 or your headphones have been turned off,
the BoomBoom 55 will automatically make a connection once the
BoomBoom 55 and the headphones are turned on again.
6.4

Pairing with another device

You can easily pair the BoomBoom 55 with another pair of
Bluetooth headphones. Switch off the already paired headset and
perform the above pairing procedure again.
6.5

On / off switch

Using the ON/OFF switch, you can turn the BoomBoom 55 on or
off.
6.6

Pairing a second Bluetooth device

With the BoomBoom 55, you can pair two Bluetooth receivers at
the same time.
After pairing the first Bluetooth device, put the second device in
pairing mode.
Now, press the BoomBoom 55's pairing button once.
The pairing with the first Bluetooth device will be momentarily
interrupted, after which both Bluetooth devices will be paired with
the BoomBoom 55. This can take up to two minutes.
6.7

Deleting paired devices from memory

To delete previously paired devices from the memory, proceed as
follows:
Turn off Boom Boom 55.

Press the pairing button and hold.

Turn on the Boom Boom 55.

Wait until the LED blinks rapidly.

Now release the pairing button.

All previously paired devices are now erased.

Continue with 6.2 to pair your Bluetooth device.

BoomBoom 55 9