Important Safety Instructions; Electrical Ratings - Lorell LLR84380 Manual Del Usuario

IMPORTANT SAFETY INSTRUCTIONS

WARNING! When using electrical appliances, basic precautions should always be followed to reduce the risk of
fire, electric shock, and injury to persons, including the following.
INSTRUCTIONS FOR USE AND CARE
1. Read all instructions before using heater.
2. This heater is hot when in use. Avoid direct contact to hot surfaces. Keep combustible materials such as
furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the heater and
keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the
heater is left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate the heater with a damaged cord or plug; if the heater malfunctions, has been dropped or
damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical
adjustment, or repair.
6. Do not use the heater outdoors.
7. This heater is not intended for use in bathroom, laundry areas and similar moist indoor locations. Never
locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away
from traffic areas where it can be tripped over.
9. CAUTION: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk
of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to
defeat this safety feature. To do so could result in an electric shock hazard.
10. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a
circuit that already has other appliances working.
11. CAUTION: It is normal for the plug to feel warm to the touch; however, a loose fit between the AC
outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified
electrician to replace loose or worn outlet.
12. To disconnect the heater, first turn controls to the OFF position, then remove plug from outlet. Never pull by
the cord.
13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surface, like
a bed, where openings may become blocked.
15. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where gasoline, paint, or
flammable liquids are used or stored.
16. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons.
17. CAUTION: Avoid the use of an extension cord because the extension cord may overheat and cause a
risk of fire. However, if you have to use an extension cord, the cord shall be No.14 AWG minimum
size and rated not less than 1875 watts.
18. The output of this heater may vary and its temperature may become intense enough to burn exposed skin.
Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to
avoid burns.
SAVE THESE IMPORTANT INSTRUCTIONS FOR EASY REFERENCE
ASSEMBLY
This heater is pre-assembled in factory.

ELECTRICAL RATINGS

This product is rated 12.5 amps (1500W) at 120V, 60 Hz.
2