Custom Harness Installation - Mopar Jeep Wrangler 2007 Instrucciones Para La Instalación

Custom Harness Installation

Ignition switch connector
A. Locate ignition switch connector,
directly behind the ignition switch.
Release the secondary lock. While
pushing on main release, remove
connector from ignition switch.
B. Connect the harness 5-way female
connector to the vehicle's ignition
switch.
C. Connect the harness 5-way male
connector to the vehicle's 5-way
ignition connector previously
removed from the ignition switch.
Ground
D. Using a supplied 1/4" screw,
secure the black ground wire with
ring terminal to the driver's side left
kick panel metal.
Parking Light Connection
E. Locate the White/Violet (L217) wire in
harness, found low in the left kick
panel area. Center-splice the
harness Yellow wire into this wire,
following the center-splice proce-
dure as shown. This wire will show
+12V when the parking lights are
turned on.
Center-Splice Procedure
6