Programming; End Of Programming - Kübler Codix 532 Manual Del Usuario

5.4.6 Maximum value acquisition
The maximum value may be saved and consulted
during operation (see 6.1)
Selection in the menu
Maximum value
acquisition on
Maximum value
acquisition off
5.4.7 Minimum value acquisition
The minimum value may be saved and consulted
during operation (see 6.1)
Selection in the menu
5.5

End of programming

When programming is finished, end the prorgamming
routine as follows:
Selection in the menu
5.4.6.1 Resetting the maximum value
This allows defining whether the maximum value can
be reset during operation or not. However, the maxi-
mum value can only be reset if the maximum value
display is the active function (see 6.1). If the maximum
value is reset, the current measured value becomes
the new maximum value.
5.4.7.1 Resetting the minimum value
This allows defining whether the minimum value can be
reset during operation or not. However, the minimum
value can only be reset if the minimum value display is
the active function (see 6.1). If the minimum value is
reset, the current measured value becomes the new
minimum value.
Minimum value
acquisition on
Minimum value
acquisition off
Programming restarts.
The set values can be
checked and modified.
Programming is finis-
hed. The set values are
used in operation.
Selection in the menu
The maximum value can
be reset using the red
key
The maximum value
cannot be reset
Selection in the menu
The minimum value can
be reset using the red
key
The minimum value
cannot be reset
17