DoorBird D10X Serie Manual De Instalación página 14

STEP 6: DOWELS
If the exterior wall of the house is not made of wood, you should drill four
holes 5 mm in diameter in the wall and then place the dowels provided into
the boreholes. If the exterior wall of the house is made of wood, you will
usually not require any dowels. There are special dowels for assembling the
video door station on an insulating wall, e.g. Fischer insulating dowels. Please
check with your insulating material manufacturer regarding which dowels
they recommend.
STEP 7: ATTACH THE MOUNTING PLATE
Put the wires that you would like to connect to the video door station
through the opening in the mounting plate provided. Position the mounting
plate against the exterior wall of the house and use the screws provided to
position it in the dowels or on the wall. The mounting plate for the video
door station has been designed in such a way that it can also be installed on
uneven walls, so it is not completely flat. The partially greater clearances at
the back also serve to stabilize temperature and moisture levels.
STEP 8: PREPARING THE WIRES
Remove about 5 mm of insulation material at the end of the wires that you
would like to connect to the video door station.
STEP 9: CONNECTING THE WIRES
It is possible to connect the video door station conveniently and safely via a
connection terminal with jacks on the reverse of the video door station.
The individual contacts on the connection terminal are labelled on the reverse
of the casing. Some connectors on the connection terminal may come provided
by us with cable. Please use appropriate crimp connectors or terminal strips
to connect the supplied cables with your wires. The accompanying crimp
connectors are weatherproof and are equipped with heat-shrink tubing which
can be sealed after assembly by, for example, carefully using a heat gun.
Please remove any cables on the connection terminal that you do not need.
14