Installation; Start-Up - CUISIMAT ZUMMO ZUMMITO Z 05 Guia Del Usuario

• Use special care when handling the blade to avoid the risk of injury. (Fig. 3)
• To prevent risks, all repairs should be performed by technical personnel.
• The company assumes no liability whatsoever if damage is due to improper machine use or
the failure to follow the instructions contained in this manual.
• Request technical service from the company that supplied that machine to you; in the event
that it cannot be located, contact the factory (data on the cover of this manual).
3

INSTALLATION

• Attention! The machine weighs 48Kg. When moving machine, we suggest that this be
accomplished by two persons. The best way to handle a machine is to use one hand to get
a grip underneath the rear and the other placed beneath the squeezing tray. (Fig. 4)
• Place the machine on a sufficiently sturdy and stable base.
• Ensure that the machine's voltage and frequency match the values of your electrical
installation. See the identification plate. (Fig. 5)
• Use an electrical outlet that is equipped with an effective earth connection. This outlet
should be used exclusively by the juice extraction machine. Do not plug other appliances
into the outlet.
• Before turning on the machine, it is recommended that the pieces that will be in contact with
juice be cleaned first (cups, balls, blade, tray, filter and plastic front).
• Turn on the power switch. (Fig. 6) If no message appears on the display (Fig. 7), this
means that there is a lack of voltage; in this case, make sure that you have plugged the
machine into a live line and that the power switch is turned on. Once this problem has been
taken care of, one of the following three messages will appear: StoP, a number , C
• If the StoP message appears on the display, the machine cannot be started up because the
safety system prevents it. In this case, check the following:
a The cover is properly in place, with its clasps properly fitted inside the slots. (Fig. 8
& 9)
b The tray that holds the squeezer and the blade are properly in place, with the
fastening screws tightened. (Fig. 10)
• If a number or the letter C appears on the display, the machine is ready for normal
operation.
4

START-UP

• Once the machine is turned on, the display will show a number between 1 and 50 or the
letter C. The number indicates the quantity of oranges to be squeezed and the letter C
means that oranges will be squeezed without interruption for approximately 30 minutes.
• Depending on the number of oranges that you want to squeeze, keep pressing the SELECT
button and the number on the display will increase from 1 to 50, and then the letter C will
appear (1,2,3,..........48,49,50,C,1,2,3.....). If you keep the SELECT button depressed for
more than 3 seconds, the number will decrease.
• Perform this operation until the desired quantity appears.
• Once a quantity is selected and an operation is performed, the machine will store this
information (even if it is shut off) until a new selection is made.
When the ON button on the panel is pressed, the machine will squeeze the number of
•
oranges shown on the display. During the process, the number of oranges left to squeeze
will appear on the display. If you want to repeat the operation, simply press the ON button.
To stop the process, press the STOP button.
14