Connecting A Vcr Or Tape Recorder - Insignia NS-A3111 Guia Del Usuario

Insignia NS-A3111 DVD Executive Shelf System
To connect a two-channel digital stereo or
A/V receiver with multi-channel decoder:
1 Connect your shelf system's COAXIAL OUT
jack to the corresponding in jack on your
amplifier. Use an optional digital coaxial
audio cable.
2 Activate your shelf system's digital output.
(See "AUDIO SETUP" on page 11).

Connecting a VCR or tape recorder

To record DVD playback:
1 To record the audio track of your DVD,
connect the left/right audio output jacks on
this shelf system to the left/right audio input
jacks on your VCR or tape recorder.
2 To record the video track of your DVD,
connect the video output jack on this shelf
system to the video input jack on your VCR
or tape recorder.
5.1/6.1 CH home theater
Back of shelf
system
Video cable
VCR or tape
recorder
3 If you have an external Dolby Digital or DTS
decoder and want to play your DVD through
external Dolby Digital or DTS decoder,
connect the digital coaxial output jack only to
the digital coaxial input jack of your decoder.
A digital coaxial audio cable is not included.
Making audio connections
To listen to the sound from an external music
device, such as an MP3, CD, or MD player,
through the speakers of this unit, connect the
AUX IN jack of this unit to the headphone output
of your music device with an audio cable, then
press SOURCE to select AUX.
DVD EXECUTIVE SHELF SYSTEM
Audio cable
Headphone output
Digital coaxial audio
cable (not included)
Audio cable
Front of shelf system
External
audio
device
www.insignia-products.com
Connecting speakers
Note
This shelf system is designed to reproduce
optimum sound quality when the supplied
speakers are used. If you want to connect other
speakers to the system instead of the supplied
speakers, they should have 4 ohms impedance.
Ensure correct polarity when connecting speakers
(colored wire for matched colored terminal clip).
Right
speaker
Colored wire
Black wire
Connect all speakers in the same manner.
Cautions
• To prevent damage to circuits, never
short-circuit the speaker output terminals.
• Do not remove too much insulation from the
wire cables to avoid the stripped
• portions from touching each other. The optimal
length for the stripped part should be around
1/3 inch (or 1cm).
• Do not push the stripped part too far into the
speaker connectors.
• Do not connect more than one speaker to any
one pair of speker terminals.
• Do not connect speakers with ampedance
lower than the speakers supplied.
Positioning the speakers
Where you place speakers plays an important
role in the reproduction of the surround sound
effect. Pay particular attention when planning
speaker layout. For the best surround effects, all
speakers should be installed.
To place the speakers:
• Place the front left and right speakers to the
left hand and right hand sides of your TV.
All speakers should be approximately the
same distance from your listening position
and must be visible.
Front speaker Front speaker
(left) (right)
TV
Viewing area
Left
speaker
Front speaker Front speaker
(left) (right)
TV
DIM L
DIM R
9