Using Your Dvd Shelf System; Getting Started; Basic Setup - Insignia NS-A3111 Guia Del Usuario

Installing your shelf system
Install your shelf system on a stable flat surface.
There must be sufficient room in front of your
shelf system for the disc tray to open. Positon
your shelf system so that it can have a direct line
of sight to the remote control.
Caution
• Do not install this shelf system in a confined
space such as a bookcase.
• Do not expose your shelf system to extremes of
temperature or humidity.
• Avoid placing your shelf system on a hot
surface such as on top of other hot running
equipment.
• Make sure that there is adequate ventilation to
your shelf system.
Notes
• Connect the AV cord only after the speakers,
antenna, and all optional equipment have been
connected.
• Never make or change any connections with
power turned on.
Using your DVD shelf
system

Getting started

To get started:
1 Finish the connection for the shelf system as
shown in the previous section.
2 Connect power to your shelf system.
3 Turn on the TV and set to the correct video-in
channel.
To turn your shelf system on:
1 Plug in your shelf system. The standby
indicator on the front panel lights up.
2 Press Standby/On. After a few seconds
the display shows "NO DISC."
3 Turn on your television and select the AV
input that your shelf system is connected to.
To start playback:
1 Press (OPEN/CLOSE). The disc tray
opens.
2 Place a DVD in the disc tray, then press
(OPEN/CLOSE). The player reads the disc
and starts playback. Before the movie starts
to play, a menu appears.
3 Select PLAY MOVIE, then press OK. The
movie starts.
4 Although you can watch a movie immediately,
to get the best results from your shelf system,
press STOP, then complete the following
system setup options. You only need to do
this when you first set up your shelf system.
10
Insignia NS-A3111 DVD Executive Shelf System

Basic setup

To use the basic setup menus:
1 Press SETUP/EXIT on the remote control to
enter the System Setup menu in stop mode.
To exit the System Setup menu, press
SETUP/EXIT again.
2 Press
menus: System Setup , Language Setup ,
Video Setup, or Audio Setup.
3 When a menu is highlighted, press
to select options within the menu.
Available options for each setting appear on
the right side of the screen.
4 Press
5 Press
press OK to confirm the changed setting.
6 Repeat Steps 3 to 5 to change the other
settings. For more information, refer to
appropriate sections in this guide.
7 When you have finished making changes,
highlight EXIT/SETUP, then press OK, or
press SETUP/EXIT again to exit the System
Setup menu.
www.insignia-products.com
or to navigate to one of these
or OK to move to the right column.
or to select a new setting, then
or