World Marketing of America Comfort Glow QSF8208R Instrucciones De Instalación página 4

ZONE HEATING SAVES!
The concept of Zone Heating is simple. Use High Efficiency heaters to heat the rooms you use most, during the
times you use these areas and turn back the thermostat to your central heating system. To achieve the
maximum benefit it is important to understand your heater and where best to locate it.
Please follow these suggestions:
1. Close doors to areas you do not wish to heat.
2. Locate a three prong outlet along an interior wall if possible. Position the heater so that the warm air
can blow unobstructed across the room towards the exterior walls.
3. Check your windows and doors for the infiltration of cold air and insulate as needed to avoid heat
loss. Rapid heat loss will minimize the effectiveness of your Infrared heater as it would any
conventional type heater.
4. Keep the area around the heater free of obstructions to insure maximum airflow. Keep electrical
cords, drapery, furniture, and other combustibles 3 feet (0.9 M) away from the front of the heater
and away from the sides.
5. Avoid locating your heater in high traffic areas or in direct sunlight.
6. Avoid locating your heater near your central heating thermostat.
LOCATING YOUR ELECTRIC FIREPLACE
Your new freestanding electric fireplace may be installed virtually anywhere in your home. However,
when choosing a location for your new electric fireplace, ensure that the general instructions are
followed. For best results, install the electric fireplace out of direct sunlight or near your central
heating thermostat
NOTE: This appliance comes equipped with an overheat protection safety device. Should the
appliance begin to overheat for any reason, it will automatically turn all heater functions of
the appliance off. The appliance will have to be reset prior to continuing use. To reset the
over-heat protection safety device, turn all controls off and unplug the appliance. Wait 15
minutes, plug the appliance back in and turn on. If the appliance continuously overheats,
please call our customer service department.
~ 4 ~