Care And Maintenance - Nexgrill 720-0786A Guia Del Propietario

ENSURE THAT THE GAS SUPPLY AND THE KNOBS ARE
IN THE "OFF" POSITION. MAKE SURE THE GRIDDLE IS
COOL BEFORE HANDLING IT.
BURNERS
Extreme care should be taken when moving a burner as it
must be correctly centered on the orifice before any attempt is
made to relight the grill. Frequency of cleaning will depend on
how often you use the grill.
MAIN BURNER CLEANING
Ensure the gas supply is off and the knobs are in the "OFF"
position. Make sure the grill is cool. Clean the exterior of the
burner with a wire brush. Clear stubborn scale with a metal
scraper. Clear any clogged ports with a straightened paper
clip. Never use a wooden toothpick as it may break off and
clog the port. Please note if insects or other obstructions are
blocking the flow of gas through the burner, you will need to
call our Customer Service Line 1-800-913-8999.
GREASE TRAY CLEANING
The grease tray should be emptied after each use and
washed with a mild detergent and warm water solution. A
small amount of sand may be placed in bottom of grease tray
to absorb the grease. Check the grease tray frequently, do not
allow excess grease to accumulate and overflow out of the
grease tray.
BURNER CLEANING
1. Turn off the gas supply, and make sure all the knobs are
in the "OFF" position.
2. Wait for the grill to cool.
3. Clean the exterior of the burner with a wire brush. Use a
metal scrapper to stubborn stains.
4. Clear clogged port with a straightened paper clip. Never
use a wooden toothpick as it may break off and clog the
port.
5. If inserts or other obstructions are blocking the flow of gas
through the burner, call our Customer Service Line at
1-800-913-8999.

Care and Maintenance

HOW TO REPLACE MAIN BURNER
Step 1. Remove the main burner "R" pin on the back wall
of fire box by using needle nose pliers. Use a flathead
screwdriver to remove burner pin cover, then remove the
burner on the front wall of fire box, as shown below.
Step 2. Insert the burner onto the orifice and secure the
burner pin cover on the burner, as shown below, make
sure burner hole aim at orifice .
Step 3. Secure the main burner on the back wall of fire box
with "R" Pin.
9
Warning: If you wish to replace main burner,
we strongly recommend that you hire a
professionally trained technician to replace it.
Please understand that we will not be
responsible for any liability, personal injury, or
property damage resulting from an improperly
assembled burner.