Brush Replacement; Environmental Protection; Symbol Identification - Ingersoll Rand W5001 Serie Manual De Instrucciones

(Dwg. 48380273)

Brush Replacement

(Dwg. 48623813)
Reduced performance, intermittent operation, or no operation are signs of worn brushes.
To check the condition of the brushes remove the battery pack from the tool. Unscrew the brush caps and remove the brushes by lifting on the
metal tab. Note the orientation of the brush when it is removed, if re-installing, it should be inserted in the same orientation. It is normal for the
brushes to wear at different rates. If either brush is below the specified length in the diagram, replace both brushes to maintain peak performance.
Reinstall brush caps and tighten to proper torque.
Parts and Maintenance
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.

Environmental Protection

When life of Ingersoll Rand electrical product has expired, it must be recycled in accordance with all applicable standards and regulations (local,
state, country, federal, etc.). Improper disposal may endanger environment.

Symbol Identification

Return waste material for recycling.
Original instructions are in English. Other languages are a translation of the original instructions.
47497350001_ed4
2
8h
1
8h
1
8h
Do not dispose of this product with
household waste material.
1
IR#
105
8h 1
< 0.354in [9mm]
Replace Replace
0.7 - 0.9 nm
OFF
6 - 8 in-lbs
2
IR#
67
Li-Ion
Product contains Lithium-Ion.
Do not dispose of this product with household
waste material.
EN
EN-2