Replace The Blade; Operation Tips - GreenWorks Pro 60V ULTRAPOWER ED60L01 Manual Del Operador

9.4

REPLACE THE BLADE

If the blade worn out, replace it with a new one (not
provided).
1. Use a metal rod (1) to fix the blade.
2. Remove the nut (2) by turning it clockwise with the
wrench (4) provided.
3. Remove the washer (3).
3
4. Remove the old blade and replace it with a new one.
5. Place the washer on the blade.
6. Place the nut on the washer and tighten it
counterclockwise with the wrench provided.
Wheel
Blade
NOTE
2
English
Loosen
9.5

OPERATION TIPS

Always hold the edger away from the body keeping
clearance between your body and the edger. Any contact
with the edger cutting head while operating can result in
serious personal injury.
• Hold the edger with your right hand on the rear handle
and your left hand on the front handle.
• Keep a firm grip with both hands while in operation.
• Edger should be held at a comfortable position with the
rear handle about hip height.
• The edger will edge along sidewalks, driveways, flower
beds, curbs, and similar areas.
• Cut at a steady pace. If the blade begins to bog down, you
are edging too fast; slow your pace. Do not force the
blade into ground.
• Light contact of the blade against the sidewalk edge,
curb, etc., is acceptable and will not damage the edger.
• Best appearance is obtained when grass is dry. Avoid
edging in wet soil or wet grass areas or the blade guard
might clog and result in an uneven edge. If the blade
guard becomes clogged, stop the edger, remove the
1
battery, and remove debris from the blade guard.
9
Tighten
4
WARNING
EN