Chamberlain ARQ TM210 Manual De Instrucciones página 3

TEST
Test the ARQ Universal Remote Control by pressing the button you programmed in
step 4. If the garage door does not move, repeat the programming steps or go to
http://arq.chamberlain.com for additional instructions.
INSTALLATION
The ARQ Universal Remote Control Frameless Mirror is ideal for vehicles with an
existing wedge-style mount bracket mirror.
MOUNT THE ARQ UNIVERSAL REMOTE CONTROL
FRAMELESS MIRROR ON WINDSHIELDS WITH A
WEDGE-STYLE MOUNT BRACKET
1. Remove existing mirror per manufacturer's
recommendation.
2. Loosen the screw on ARQ Universal Remote
Control Frameless Mirror using Torx wrench
(provided).
3. Slide the ARQ Universal Remote Control
Frameless Mirror onto the bracket on the
windshield.
4. Tighten the screw to secure the ARQ Universal
Remote Control Frameless Mirror into place.
NOTE: For vehicle windshields without a
wedge-style mount bracket, you can purchase a
wedge-style bracket from an automotive parts
retailer. Please install mirror with care,
Chamberlain Group does not accept responsibility
for the installation of this replacement mirror.
TO REMOVE THE ARQ UNIVERSAL REMOTE
CONTROL
1. Press on the back side of the clip and pull down.
2. Remove the ARQ Universal Remote Control from
mirror. DO NOT remove while vehicle is moving.
TO REPLACE THE ARQ UNIVERSAL REMOTE
CONTROL
1. Insert the new ARQ Universal Remote Control in
the mirror.
2. Secure it by rotating the clip upwards until it
snaps into place. DO NOT replace while vehicle is
moving.
Wedge-Style Mount Bracket
(on windshield)
Screw
Clip