Lamp Replacement; Safety Precautions - König Electronic DL-STROBE75 Manual De Uso

OPERATION:
Read "important information before use" first and verify all precautions are fulfilled before operating.
Make sure the correct lamp is installed, read "service" how to (re)place the lamp.
The STROBE75 is fully automated. The lamp turns on as soon as power is applied and will start
flashing immediately. The flash speed can set manually by turning the knob on the back panel
or by connecting an optional remote control to the Jack input socket. Up to 8 strobes can work
synchronously by linking the Jack in-/outputs.
Although the STROBE75 cannot be dimmed, it may be switched on and off remotely using switch
packs or the full-on and full-off levels on dimmer packs. Disconnect the fixture from AC power when
not in use.
SERVICE:
There are no user serviceable parts inside except the lamp and fuse. Refer all service to a qualified
technician.

Lamp replacement:

1. Disconnect the fixture from AC power and allow it to cool for 15 minutes.
2. Remove the dome cover by turning it to the right and lift it.
3. ATTENTION: The inside capacitor is loaded even when the fixture is disconnected from AC power.
Discharge the capacitor before touching inside parts to prevent an electric shock!
4. Remove the base of the old lamp from the socket by loosening the three screws.
5. Install the new lamp: DL-LAMPSTRB75 - 75W xenon.
Push the lamp base pins gently into the socket.
To ensure maximum lamp life, avoid touching the lamp with bare hands.
Replace the main fuse:
1. Unplug the mains cable from the outlet socket and allow it to cool for 15 minutes.
2. Remove the dome cover by turning it to the right and lift it.
3. ATTENTION: The inside capacitor is loaded even when the fixture is disconnected from AC power.
Discharge the capacitor before touching inside parts to prevent an electric shock!
4. Replace the fuse with one of the same type. The fuse rating is listed on the rating label.
SPECIFICATIONS:
• Speed control: 1-15 flashes/sec
• In- and output: 2x 6.3 mm Jack
• Input for remote control (not included)
• Up to 8 strobes synchronized
• Adjustable mounting bracket
• Lamp: DL-LAMPSTRB75 - 75W xenon (included)
• Power supply: 230 V AC - 50/60 Hz
• Dimensions (HxWxD): 212 x 212 x 267 mm
• Weight: 1.5 kg

Safety precautions:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
from mains and other equipment if a problem should occur.
To reduce risk of electric shock, this product should ONLY be opened by
an authorized technician when service is required. Disconnect the product
3