Kenmore 580.72089 Manual Del Propietário página 7

Q Select the position that wilt place the sill supports
near the outermost point on sill (FIGo 10)
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
Lower guide , ,, _. _, _&
' / 'N
CaNnel
_ Place the sill supports with the cabinet on the
window sill's selected position
_ti] The cabinet should be installed with a very
slight tilt (about 1/4") downward toward the outside
(FIG 11),,
Adjust the bolts and the nuts of sill supports to level
the cabinet.,
J _ _------ fo
TEM B FIG. 11
_ Attach the cabinet to the inner sill by driving the
screws (_TEM F) through the front angle into the
window inner sill (FIG, 12),,
i I:I Ir
. -- Lower Guide
I_ tTEM F
ITEM B FIG. 12
[]Pull each side curtain fully to each side of
window opening
Attach each side curtain to the window sash using
screws (ITEM G). (FIG, 13)
ITEM G
FIG. 13
_] Attach the L BRACKET (ITEM J) with screw
(ITEM G)., (FIG, 14)
/ ]II ,TEM
_ FIGo 14
_] DRAINAGE
Be sure to insertthe drain pipe into base pan before
installation.,
The air conditioner must be installed with a slight tilt
downward to the outside for proper water drainage°
The air conditioner will drain the excess condensed
water through the drain pipe (FIG, I5)
DRAINp_BASE PAN REAR
'-'-In.,,_ BASE PAN BOTTOM
FIG. 15
_ Slide the chassis into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side
screws you removed in step I.
[_r
Screw "_,,_
FIGo 16
Screw
_Cut the foam strip (ITEM H) to the proper length
and insert between the upper window sash and the
lower window sash,, (FIG, 17)
FIGo 17
_The vent control handle must be straightened
before the decorative front is attached
Putl out part @ to align with part (_.
.Part(
FIG. t8
-7_