Lincoln industrial Mityvac 07201 Manual Del Usuario página 5

5. Place the selector valve mounted on the side of the pump assembly to "EVACUATE".
6. Raise the pump handle on the reservoir tank until it reaches its highest limit. Pump the handle approxi-
mately ten times. The unit will begin to extract the coolant from the cooling system.
7. Once the coolant has been extracted, remove the expandable rubber plug from the reservoir tank;
pour the coolant from the tank into a suitable container, and dispose of it in an appropriate manner.
Rinse out the reservoir tank with clean solvent or engine degreaser. Allow it to dry thoroughly.
8. If you wish to use the Fluid Evacuator Plus to dispense coolant from the Fluid Evacuator Plus, fill the
cleaned reservoir tank with new coolant and simply switch the selector valve that is mounted on the
side of the pump assembly to "dispense".
9. Pull up on pump handle and continue pumping until the cooling system is filled to the desired level.
10. Be sure to run the engine until it reaches operating temperature to circulate the new coolant and then
re-check the level to be sure that it is full.
Extracting Brake Fluid from the Master Cylinder
1. Clean the exterior of the master cylinder and master cylinder cap. (This will prevent dirt from entering
the master cylinder reservoir when the cap is removed.)
2. Remove the lid of the master cylinder reservoir.
Prior to inserting the extraction tube into the master cylinder reservoir, be sure that the extraction tube
is clean and free of any other types of fluid. Failure to do so would result in contamination of the brake
fluid in the hydraulic system and cause potential brake failure.
3. Select the appropriate "dipstick" tube and connect it to the main suction tube.
4. Insert the opposite end of the main suction tube into the 10mm x 90° tube connector on the top of the
reservoir tank. Take care that tube is in the connector all the way to prevent leakage.
5. Place the selector valve mounted on the side of the pump assembly to "EVACUATE".
6. Insert the end of the extraction tube into the master cylinder reservoir.
7. Raise the pump handle on the reservoir tank until it reaches its highest limit. Pump the handle
approximately ten times. The unit will begin to extract the brake fluid from the master cylinder reser-
voir.
8. Once the break fluid has been extracted, remove the expandable rubber plug from the reservoir tank;
pour the break fluid from the tank into a suitable container, and dispose of it in an appropriate manner.
Rinse out the reservoir tank with clean solvent or engine degreaser. Allow it to dry thoroughly.
9. After all repairs are accomplished, refill the system with new, manufacturer approved brake fluid from
a sealed container.
Form 822823
Page Number - 5