Establish Communication To The Processor - AB Quality SLC 5/03 Instrucciones De Instalación

8 SLC 5/03™, SLC 5/04™, and SLC 5/05™ Modular Processors
Power Supply and LED Indicators
POWER RUN
FLT
BATT
POWER RUN
FLT
BATT
Load Your Software
Refer to your programming software documentation.

Establish Communication to the Processor

1. Refer to the following table to establish communication between the
processor and your personal computer.
Processor: Procedure:
SLC 5/03 Connect 1747-PIC from the processor to your personal computer serial port or connect
1747-UIC from the processor to your personal computer USB port to the processor using
the 1747-C13 or 1747-CP3 cable. You can also use a 1784-KTX, -PKTX, or -PCMK
interface, or a 1747-CP3 cable from channel 0 of the processor to the personal computer
serial port.
SLC 5/04 Connect a 1747-CP3 cable from channel 0 of the processor to the personal computer
serial port or connect 1747-UIC from channel 0 of the processor to your personal
computer USB port, or use a 1784-KTX, -PKTX, or -PCMK interface.
SLC 5/05 Connect a 1747-CP3 cable from channel 0 of the processor to the personal computer
serial port, or connect 1747-UIC from channel 0 of the processor to your personal
computer USB port. For Ethernet connection, connect channel 1 of the processor and the
PC Ethernet Card to an Ethernet hub using 10Base-T compatible cable.
(1) Ethernet IP address must first be set via BOOTP or an RS-232 connection.
Publication 1747-IN009D-MU-P - November 2003
FORCE
DH485
RS232
SLC 5/03
FORCE
DH+
RS232
SLC 5/04
Indicates the LED is OFF
Indicates the LED is ON
Indicates the LED is FLASHING
Status of LED does not matter
POWER RUN FORCE
FLT ENET
BATT RS232
SLC 5/05
(1)