Magic Care MrBeetle P0406EM F400 Manual De Instrucciones página 9

hours, F2000: 2000 hours.
• Repairs must be performed by authorized personnel only. Any unauthorized repairs will void the warranty
and may pose a safety hazard for the user.
WARNING: Do not modify this equipment without authorization of the manufacturer
• The Manufacturer, the Retailer and the Importer are responsible for the safety, reliability and performance
of the device only if: a) the device is used in accordance with the operating instructions b) the electrical
system of the premises where the device is used is in compliance with current laws.
s • Interactions: The materials used that come into contact with medications have been tested with a wide
range of medications. However, due to the variety and continuous evolution of medication, the possibility
of a chemical interaction cannot be excluded. We recommend that once the medication has been opened
you should use it as soon as possible and avoid prolonged contact of the medication with the nebulizer.
• The manufacturer should be contacted for reporting problems and/or unexpected events related to device
operation.
inStrUCtionS For USe
Before each use, the nebuliser and accessories should be cleaned according to the instructions in the
section"CLeAninG, SAnitizAtion, DiSinFeCtion AnD SteriLizAtion". A personal use of the nebuliser and
its accessories is recommended in order to avoid any risks of infection.
1. Plug the power cord (A6) into the socket (A5) at the rear of the unit and plug the power cord into a power socket
corresponding to the voltage of the unit. This must be positioned so that it is not difficult to make the disconnection
from the mains.
2. Open the nebuliser by turning the upper part (C1.3) counterclockwise.
3. Pour the medication prescribed by the physician into the lower part (C1.1). Close the nebuliser by turning the
upper part (C1.3) clockwise.
4. Connect the accessories as shown in the "Assembly diagram". The cap (C1.4) provided with the nebuliser RF6 basic
makes it possible to deliver the medication in 2 modes:
"standard mode", for optimum delivery and
minimum waste of medication
5. Start the unit by means of switch (A1) and breathe in and out deeply.
6. When the treatment is finished, turn off and unplug the unit.
7. If after the therapy session moisture accumulates in the tube (B), remove the tube from the nebulizer and dry it
using the compressor air flow; this operation will prevent mold from forming inside the tube.
CLeAninG, SAnitizAtion, DiSinFeCtion AnD SteriLizAtion
Turn off the unit before any cleaning and disconnect the power cord from the mains.
CLeAninG tHe DeviCe AnD tHe tUBe'S oUter SUrFACe
Only use a cloth dampened with antibacterial detergent (non-abrasive and free of solvents of any kind).
"high speed mode", for a quicker treatment
If you use the face mask, fit it to the
face as shown in the picture
9
2