Selecting A Program For Operation; Operation Screen; Circulation Pump - Selecta DIGITERM TFT-200 Manual De Instrucciones

INSTRUCTION MANUAL
Selected program.
PROGRAM 00
TEMPERATURE: 16.0ºC TIME: 00:00
UNDERTEMP: 0ºC OVERTEMP: 0ºC
HOME
SETUP
Fig 7.3. Programming screen
SEL change to yellow

colour when program is
selected
PROGRAM 04
TEMP: 50.0ºC TIME: 00:00
UNDERTEMP: 0ºC OVERTEMP: 0ºC
HOME
SETUP
Fig 7.4. Selecting a program
28.9
ºC
50.0
SET
Fig 7.5. Operation screen
Fig 7.6.1 INTERNAL circulation.
Fig 7.6.2 EXTERNAL circulation.
J
.P. SELECTA s.a.u. - Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
CODE 80296 REV A
Fig 7.3 screen is displayed.
Program selector.
Select a program (from 00 to 09) with keys:
Set working temperature and the other parameters:

SEL
Press:
Keys
SAVE
In a similar way press:
HH:MM:SS DD/MM/YY

SEL

7.4 Selecting a program for operation

SAVE
To select a stored program press over SEL (Fig 7.4).
HH:MM:SS DD/MM/YY
(SEL indication changes its color to yellow).
Once selected, this program in placed on the TASK screen.
PROG 04
SET -- h -- m

7.5 Operation screen

T 00 h 00m
On the operation screen «TASK», the program selected (PROG 04) on the
FLOW programming screen is shown (Fig 7.5) and it starts when pressing over
80%
This screen shows:
HH:MM:SS DD/MM/YY
Actual temperature
Temperature set
Working time set (SET)
Elapsed time

7.6 Circulation pump

The liquid circulation pump could operate in two configuration modes:
- INTERNAL circulation:
Water (or other) will be pumped from horizontal pump output (See fig 7.6.1).
Use this configuration to made water circulation into the bath vessel in order
to homogenize the temperature from sample load.
- EXTERNAL circulation:
Water (or other) will be pumped from vertical pump output (See fig 7.6.2).
Use this configuration to made water circulation out of the bath vessel in order
to temperate an external equipment. This is the factory setting.
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
Mar/2017 (It can be modified without notice)
TEMP: 16.0ºC
will be shown to select temperature.
Sets de working time.
TIME: 00:00
A time setting value of 00.00 means «conti-
nuous operation».
Sets the undertemperature alarm value.
UNDERTMP: 0ºC
Sets the overtemperature alarm value.
OVERTMP: 0ºC
Press to save .
SAVE
Page: 18
.