Safety Belt - Peg-Perego pliko p3 Instrucciones De Uso

PERFORMED BY AN ADULT.
• DO NOT LIFT THE STROLLER BY
GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO
WITH STAND LOADS.
• ENSURE THAT THE STROLLER IS
OPENED CORRECTLY AND LOCKED
IN POSITION OF USE.
• CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
• DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON
STAIRS OR ESCALATORS.
• DO NOT USE THE PRODUCT IF IT
HAS BROKEN OR MISSING PARTS.
• DO NOT USE NEAR FIRE OR
EXPOSED FLAME.
• NOTICE: THIS ARTICLE MEETS OR
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.
instructions for use
OPENING
1• Before opening the stroller remove the two
protective caps from the hooks as shown in
the fi gure. Otherwise, the stroller will not open
correctly.
2• To open the stroller, pull up the two levers on
the handles and
3• at the same time, lift the stroller, which will
open automatically. To make sure that the
stroller has been set up correctly, check the
two side hooks (see fi gure).
ASSEMBLYING THE STROLLER
4• To mount the front wheels, lower Lever A and
slip the wheels onto the axle, as shown in the
fi gure. Press until the wheels click into place.
5• To assemble the rear wheels fasten the wheels
connected by the break wire, as indicated in
the fi gure.
6• Carefully distinguish the left wheel from the
right, to fasten the two rear wheels properly.
The left wheel has a rib on the wheel tube
and one on the chassis to guarantee proper
fastening (see fi gure).
7• Make sure that it is fastened properly, as
indicated in the fi gure (click).
8• The stroller comes with caps on the armrests.
To attach the front bar, remove the caps fi rst.
(Keep the caps, in case you want to use the
stroller without the front bar). To remove the
caps, press the buttons under the armrests
while pulling the caps off .
9• To attach the front bar, insert the two ends of
the bar into the armrests and press until the
bar clicks into place, as shown in the fi gure.
10• To mount the basket, slide the slots onto the
front hooks A and the rear hooks B and C.
11• The fi gure shows the mounted basket.
12• The drink holder can be placed on the left or
right hand side of the stroller, thanks to the
attachment which is already fi tted on both
sides. To fi t the drink holder, click it on, as in
Figure A. See Figure B for a fi tted drink holder.
Do not put hot drinks in the drink-holder, nor
items weighing more than 0,5 kg (1 lbs).
PLIKO P3 VERSIONS
13• "Classico" Model: comes with a hood.
HOOD
• The hood comes with a zipper, for attaching
the zip-on rain canopy or mosquito netting
(see Accessories Line).
14• To mount the hood, push the fi ttings down
until they click, as shown in the fi gure.
15• As shown in the fi gure, button the hood inside
the armrest and the backrest of the stroller.
16• To stretch out the hood, push the coupling
downward. The hood can be reclined by
following the inclination of the backrest.
17• The hood is supplied with the front border
folded up. It should not be used like this
however. In order to be able to use the hood
correctly, turn the edge up, as in the fi gure.
18• It is possible to detach the back part of the
fabric by unzipping it and use the hood as a
sun canopy.
19• To reattach the back part of the fabric, proceed
as indicated in the fi gure.
20• By lowering the stroller backrest, the hood
extends and, thanks to the double zipper, a
window can be created to allow more air to
circulate and see the child when sleeping.
21• To remove the hood, you must unbutton it
from the stroller, loosen the couplings and raise
the tabs of the fasteners, pushing towards the
inside of the stroller.
BRAKE
22• To apply the brakes, push down with one foot
the bars on the rear wheels, as shown in the
fi gure. To release the brakes, draw the bar up.
Always set the brakes on the stroller when
it is not in motion.

SAFETY BELT

23• A: Make sure that the brace is properly inserted
by pushing as shown in the fi gure. B: Fasten the
belt as shown in the fi gure.
24• To unfasten the belt, press on the buckle sides
and pull out the waist strap.