Time-Delayed Switch-Off; Child Lock; Cleaning / Maintenance; Cleaning & Maintenance - Profi Care PC-LR 3083 Manual De Instrucciones

Time-delayed Switch-off

You can set a time-controlled switch-off for the appliance.
NOTE:
This is only possible when the appliance is switched on.
• Use the TIME button to select a time setting between
and .
• Upon expiry of the timer, the appliance will switch off
automatically.

Child Lock

Press and hold the button for about 3 seconds to acti-
3s 3s
vate or deactivate the child lock. This prevents the operation
of the appliance. CHILD LOCK
when the childproof lock is activated.
WARNING:
• Switch off the appliance before cleaning and maintenance. Dis-
connect the power adapter from the electrical outlet.
• Never immerse the motor housing in water for cleaning. It could
result in an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Clean the motor housing with a dry cloth, without
additives.
You can moisten the cloth slightly to wipe away extreme
soiling.
• If the FILTER REPLACE button flashes, the filter has to
be cleaned or replaced.
NOTE:
Despite this message, the appliance may still be operated
with confidence. After you have cleaned or replaced the
filter, press the FILTER REPLACE button for approx.
3 seconds. The lighting of the button goes out.

Cleaning the Filter Element / Replacing the Filter Element

1. Turn the appliance upside down.
2. Open the cover by unscrewing and removing it coun-
ter-clockwise.
50
PC-LR3083_IM_new2_14.01.2021
lights up in the display

Cleaning / Maintenance

Ionizing Function

The electronic ionization of the air causes dust particles to
become electrostatically charged. As a result, they combine
to form larger particles and thus get caught by the HEPA
filter in a more reliable manner.
• Press the ANION button to activate or deactivate the
ionization function.
NOTE:
If the ionization function is activated, the ANION button
lights up on the control panel.
3. Remove the filter insert. If required, you may clean the
filter element by beating it slightly or wiping it gently with
a soft brush or a damp cloth.
CAUTION:
Do not immerse the filter element in water!
Replace the filter if it is heavily soiled.
einstall the filter insert.
4. Tighten the cover clockwise. Pay attention to the
notches.

Cleaning the Sensor

NOTE:
• Only clean the sensor after the filter element has been
cleaned or replaced.
• If the sensor is the only component that is cleaned
it will become dirty very quickly. This may cause the
displayed air quality to be no longer accurate. It is
therefore necessary to always clean both the filter
element and the sensor.
1. Open the cover on the back of the appliance.
2. Clean the sensor and the rest of the area at least once
every two months. Vacuum the area with a vacuum
cleaner.
3. Close the cover again. It must audibly engage.
14.01.21