Unpacking And Removing Shipping Bolts - LG WD1873RDS Manual Del Propietário

Unpacking and removing shipping bolts

When removing the washer from the carton base,
be sure to remove the foam drum support in the
middle of the carton base.
If you must lay the washer down to remove the
base packaging materials, always lay it carefully on
its side.
Do NOT lay the washer on its front or back.
INSTALLATION INSTRUCTIONS
1
Remove the bottom two shipping bolts with
the wrench (included) to fully loosen all four
shipping bolts by turning them counterclockwise
and then pulling them out.
Shipping
bolt
2
Locate the four hole caps included in the
accessory pack and install them in the shipping
bolt holes.
Cap
NOTE
y Save the bolt assemblies for future use. To
prevent damage to internal components, DO
NOT transport the washer without reinstalling
the shipping bolts.
y Failure to remove shipping bolts and retainers
may cause severe vibration and noise, which
can lead to permanent damage to the washer.
The cord is secured to the back of the washer
with a shipping bolt to help prevent operation
with shipping bolts in place.
13
Retainer