Advanced Operation - KlipXtreme RefleXion Manual Del Usuario

• While charging, the LED is solid red. When the battery has reached full capacity,
the red LED will go off.
• When the battery is running low, a tone will be generated once every few
seconds to warn you before it is totally drained.
V. Advanced operation
Note: Before installing this product, please make sure your device has the built-in
feature available. If your device is not Bluetooth
Bluetooth
®
purchase a Bluetooth receiver.
®
Pairing the speaker with your mobile device
1. Make sure the speaker is off.
2.
Place both devices not more than one meter away from each other.
3.
Verify that the Bluetooth function on your mobile device has been enabled.
®
4.
Press and hold the power button on the speaker to turn it on.
5.
The LED first blinks fast to indicate that the device has entered into the pairing
mode and is ready to be detectable for the first time.
6.
For mobile devices that are NFC-capable, simply place it close to the sensor
located on the side, to instantly establish a Bluetooth
one-step pairing configuration.
7.
On your mobile phone, tap the newly discovered audio device (KWS-614)
displayed in the Bluetooth list.
®
-enabled, you must
®
connection, in a convenient
®
8. When the speaker asks if you want to pair with it, click Yes or OK to accept.
9. If you have a lower Bluetooth version, you may be prompted to enter the
®
passkey 0000 (4 zeros).
10. If pairing is successful, a tone will be heard and the blue LED will start blinking
slowly to confirm that the connection has been established. If after 60 seconds
the pairing process fails, please repeat steps 1 through 7 described above.
11. We recommend turning off the device when not in use, to conserve battery
power.
Using the speaker with Bluetooth
1. Answering and ending a call using your mobile device
When there is an incoming call, the speaker will generate a tone to alert you of
•
this event.
Briefly press the Handset button to pick up. You may also press the answer
•
button on your cellular phone to take the call using the speaker.
Speak with a clear voice right into the built-in microphone located on the side of
•
the speaker.
To end a call, tap the Handset button once again. Likewise, you may also end the
•
call directly using the command on your cell phone.
When listening to music using your mobile phone, playback will resume
•
automatically once the call has ended.
By pressing the Handset button twice, the phone will dial the last number called
•
(supported devices).
®
technology