Advanced Operation; Troubleshooting - KlipXtreme Aristos Manual De Instrucciones

VI. Advanced operation
Pairing the soundbar with your Bluetooth
Note: Before installing this product, please make sure your device is compatible
with Bluetooth ® .
1. First turn on the soundbar pressing the Power button
on the remote control, if you haven't done so already, and select the BT mode
by pressing the Mode selection button or the BT button in the remote control.
The BT indication will appear on the display.
2. Place both devices not more than one meter away from each other.
3. Enable the Bluetooth function on your audio device and set it to discover the
®
wireless soundbar.
4. The BT icon will start blinking to indicate that the system has entered into the
pairing mode.
5. Once the soundbar appears listed under the newly found Bluetooth
(KSB-150), the pairing process will start.
6. If pairing is successful, another short sound will be heard, and the BT icon will
stop blinking.
7.If after 60 seconds the pairing process fails, please repeat steps 1 through 6
described above.
® device
on the top panel or
® devices

Troubleshooting

Problem
The unit is not turning on. Check and make sure the power cord is connected
correctly to the power source.
There is no sound coming - Make sure the audio cable is connected correctly.
from the soundbar, or the - Turn up the volume slowly.
sound is distorted. - Press the Mute button in case it was pressed
accidentally muting the soundbar.
- Press the Play/Pause button.
- Set your TV in the audio output mode that goes
accordingly with the mode setting on the soundbar.
The remote control - Install two AAA 1.5A batteries in the remote.
doesn´t work. - Replace the current batteries with new ones.
- Point the remote control toward the front of the sound
bar, and make sure it is within the operating range.
I can´t disconnet the Press and hold the BT button on the remote control for
about 2 or 3 seconds, or the Mode selection button on
soundbar from the
®
Bluetooth mode by pressing the soundbar for about 5 or 6 seconds to disconnect the
the BT button. BT device. The BT mode indicator will start flashing when
it is waiting for reconnection.
The buttons on the Unplug the soundbar, plug it to a power supply and turn
soundbar don´t work. it on again.
Solution