Paddling Pool
Introduction
We congratulate you on the purchase of your new
product. You have chosen a high quality product.
Familiarise yourself with the product before using it
for the first time. In addition, please carefully refer
to the operating instructions and the safety advice
below. Only use the product as instructed and only
for the indicated field of application. Keep these in-
structions in a safe place. If you pass the product
on to anyone else, please ensure that you also
pass on all the documentation with it.
Intended use
This article is intended for use for playing / paddling.
This product is intended for private, outdoor use only.
The product is not intended for commercial use.
Description of parts
and features
End cap
1
Valve opening
2
Stopper
3
Patches for repairs
4
Technical data
Dimensions:
approx. 195 x 195 x 39 cm
(when inflated)
Weight:
approx. 2750 g
Contents
1 paddling pool
2 screw-on-valve
2 patches for repairs
1 instruction manual
8
GB/IE
Safety advise
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE
REFERENCE!
Avoid the risk of injury!
LOSS OF LIFE OR ACCIDENT
TO INFANTS AND CHILDREN!
Never leave children unsupervised with the
packaging material or the product. The packaging
material presents a suffocation hazard and there
is a risk of loss of life from strangulation and / or
drowning. Children often underestimate danger.
Always keep the product out of reach of children.
WARNING! Never leave your child
unattended – drowning hazard.
WARNING! Only for domestic use.
Children can drown in very small amounts of
water. Empty the pool when not in use.
Do not install the paddling pool over concrete,
asphalt or any other hard surface.
When filling with water, the maximum depth of
the water should not exceed the maximum water
level mark on the product. (see fig. D).
Once inflated, make sure that the product does
not come in contact with stones, gravel or other
sharp objects which could puncture the item.
Operation
Note: Before using the product for the first time,
check it carefully for holes, porous places and seams
that are not airtight.
Recommendation: Pump the product up and
leave it alone for one day. Let a new product air
outside in fresh air for a couple of days.
RISK OF