Cleaning And Maintenance - OWIM crivit HG00442 Instrucciones De Utilización Y De Seguridad

Recommendation: Place the activity toy on a
level surface at least 2 m from any structure or
obstruction such as a fence, garage, house, over-
hanging branches, laundry lines or electrical wires.
Pumping up the product
CAUTION! Inflatable plastic products react sensi-
tively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 °C and rises above 40 °C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the pool up. Make sure that you do
not pump too much air into the product. On no ac-
count should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
tear. Only use manual pumps and / or pumps specifi-
cally designed for use with inflatable plastic products.
R oll the product out first and then check for
holes, tears and other damage (see Fig. A).
Note: You will need a pump with conical ad-
apter with a diameter of approx. 17.5 mm for
the screw valve
2
T urn the end cap
1
anti-clockwise off the air valve in order to open it.
Pump the product up.
IMPORTANT! Keep in mind that air tempera-
ture and weather conditions can affect the air
pressure inside inflatable products. In cold
weather the product behaves as if it has less air
pressure in it because the air inside contracts.
Under these conditions you may have to add
air. In hot weather the air inside expands. Un-
der these conditions you may have to remove
air in order to avoid overfilling.
T urn the end cap
1
clockwise onto the air valve to close it.
Deflating the product
T urn the stopper
3
air valve.
to inflate the product.
of the valve opening
of the valve opening
anti-clockwise to open the
A llow the air to escape completely.
S lowly fold the product together (see Fig. A).
Note: Make sure that the product is completely
dry before folding it together.

Cleaning and Maintenance

O n no account should you use corrosive or
scouring detergents.
U se a slightly damp, lint-free cloth to clean the
product.
Change the water of paddling pools frequently
(particularly in hot weather) or when noticeably
contaminated.
Repairing the product
Note: Minor damage can be repaired by the
owner using the supplied repair kit. Have any major
damage carried out at a specialist repair shop.
F irst let all the air escape from of the product.
C ut the patch
Note: Ensure that the patch
the hole and overlaps the edges of the hole.
2
R ound off the sides of the patch
off the protective foil.
P lace the patch
down firmly. If necessary, stand a heavy object
on the patch
W ait for 24 hours before you pump up the
product again.
Storage instruction
M ake sure that the product is completely dry
2
both inside and out when wishing to store it for
any length of time. Otherwise mildew and
mould may form.
S tore the product in a dark, dry place – out of
reach of children.
The ideal storage temperature is 10–20 °C.
to suit the size of the hole.
4
is larger than
4
and pull
4
on the hole and press it
4
.
4
GB/IE 9