Warnings And Limitations - enea EC0020 Guia De Inicio Rapido

The reset procedure must be carried out in accordance with the
above instructions, otherwise, you may damage the manual call
point and/or its key.
On reset, the flag will withdraw but the LED will stay on until it is
reset from the control panel.
Connect the EC0020 manual call point the control panel by means
of STP cable (2 pole). This cable will provide the power to the
various devices and to the two-way digital communication channel.
It is not necessary to respect the input/output configuration of
the terminals as the Loop
interchangeable.
The backbox has standard wall-mount anchor screw holes.
Insert the forked-end of the reset key into the two slots and push
against the back-locking clips to open the manual call point.
Remove the two serial-number stickers located under the
device details label and put one on the manual call point
housing and the other on the system layout.
After installing all the loop devices, work carefully through the
configuration and addressing procedures (refer to the control
panel manual for the respective instructions).
Test and maintenance
Test the manual call point immediately after installation and
then regularly during the periodic tests which must be carried
out in accordance with the local laws in force.
Using the EITK-DRV driver
The EITK-DRV driver allows you to change the operating
parameters of the loop
diagnostics. It is capable of operating autonomously by way of its
battery or can be connected to the USB port of a PC equipped
with the necessary software.
For details regarding use of the EITK-DRV driver, refer to the
respective instruction.

Warnings and limitations

The EC0020 manual call point can be used exclusively with
control panels using INIM Electronics OpenLoop protocol.
It is not suitable for outdoor installation unless adequately
housed inside a heavy duty weather proof box.
CE marking and certifications
DoP, EC DoC and certificates related to this product can be
downloaded from the following link:
www.inim.biz/certifications
INIM Electronics reserves the right to change
the technical specifications of this product
without prior notice.
INIM ELECTRONICS S.R.L.
Via Dei Lavoratori 10 - Fraz. Centobuchi
63076 Monteprandone (AP) - Italy
Tel. +39 0735 70 50 07
Fax + 39 0735 70 49 12
www.inim.biz info@inim.biz
4
Installation
IN and OUT terminals
devices and carry
ATTENTION!
are
ATTENTION!
out accurate
Addressable Type A indoor re-settable manual call point with
short circuit isolator for fire detection and fire alarm systems
EC0020
installed in buildings