9. Burns can occur from touching hot metal parts, hot water or
steam. Use caution when you turn a steam iron upside down –
there may be hot water in the water tank.
10. If the iron is not operating normally, disconnect from the power
supply and have the iron serviced by an authorized service
center.
11. Deposit or Mineral in tap water will generate limescale and
eventually block the steam holes, therefore it is advisable to use
distilled water.
12. When placing the iron on a stand, ensure that the surface on
which the stand is placed is stable.
13. The iron is not to be used if it has been dropped, if there are
visible signs of damage or if it is leaking.
SPECIAL INSTRUCTIONS
To avoid a circuit overload, do not operate another high
•
wattage appliance on the same circuit.
If an extension cord is absolutely necessary, a 10-ampere cord
•
should be used. Cords rated for less amperage may overheat.
Care should be taken to arrange the cord so that it cannot be
pulled or tripped over.
SAVE THESE INSTRUCTIONS
POLARIZED PLUG INSTRUCTIONS
This appliance is equipped with a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this plug will fit
into the polarized outlet only one way. If the plug does not properly
fit into the outlet at first, reverse it. If it still does not fit, contact a
competent qualified electrician. Do not attempt to modify the plug in
any way.
For appliances equipped with a standard plug, simply insert the plug
into the outlet without paying attention to the way you plug it.
3
Assembly page 3/20
USK DA 31750 - 091222