Hardware Installation; Wall Mounting - Intellinet Network Solutions 525787 Guía De Instalación Rápida

Wireless AC1750 PoE Access Point • Quick Install Guide
This guide presents the basic steps to set up and operate this
device. For detailed instructions and specifications, refer to the
user manual on the enclosed CD or at intellinetnetwork.com.

HARDWARE INSTALLATION

Refer to the images on Page 2 as needed.
1. Connect a router or PoE switch to the access point's LAN 1
port (B) using Ethernet cable. PoE switches must be
connected to the access point's LAN 1 port.
• If you are using a router, connect the included power
adapter to the access point's 12VDC jack (A) and plug then
plug the adapter into a power outlet.
• If you are using a PoE (Power over Ethernet) switch, then it
is not necessary to use the power adapter — the access
point will be powered by the PoE switch.
• Regardless of what powers the access point, set the On / Off
switch (J) to On. The LED (L) lights blue, then purple while
the access point starts up, then lights blue again when
ready for operation.
2. Connect a local network client or switch to the access point's
LAN 2 port (C), which can support powered devices.
3. Attach the three antennas to the connectors (K).

Wall Mounting

The included wallmount materials allow you to place the access
point on a vertical surface to save shelf or desktop space.
1. Attach the two magnetic wallmount bars (O) to a flat surface
using the included screws (N) and, if needed, anchors.
2. Set the magnets (M) on the back of the access point against
the two magnetic bars. The access point should be oriented
as shown on Page 2.
4
ENGLISH
English