Cautions For Use - Silver Eagle SE140A Guia De Inicio Rapido

Model:
www.matcotools.com
WARNING
Users of this tool should review the chemical composition of the work
surface and any products used in conjunction with this tool for any
such chemicals prior to engaging in any activity that creates dust
and/or microscopic particles.
Users should obtain the Material Safety Data Sheets for all identified
chemicals, whether from the manufacturer or their employer, and
proceed to study, understand and follow all instructions and warning
for exposure to such chemicals.
Some examples of these chemicals are: lead from lead based paints;
crystalline silica from bricks, cement and other masonry products;
and arsenic and chromium from chemically treated lumber. A list of
the chemicals can be obtained at www.oehha.ca.gov under
Proposition 65.
In order to reduce their exposure to such chemicals users should
always:
- Work in well-ventilated areas.
- Wear appropriate safety equipment and clothes that are specifically
designed to filter our microscopic particles.
The oil and water extractor should not be mounted on or near the air
compressor.
The temperature of air is greatly increased during compression. As the air
cools down to room temperature in the air line while on its way to the air
power tool, the moisture contained in it condenses. Thus, for maximum
effectiveness, the oil and water extractor should be mounted at some point
Pitch pipe back toward air receiver
Compressor unit
Drain
Daily
SE140A
in the air supply system where the temperature of the compressed air in the
line is likely to be lowest. Air lines must be properly drained daily. Each low
point in an air line acts as a water trap. Such points should be fitted with an
easily accessible drain. See diagram below. Pitch all air lines back towards
the compressor so that condensed moisture will flow back into the air
receiver where it can be drained off. Drain daily.
SUGGESTED AIR LINE CONNECTION
PIPE SIZE, I.D. (Inches)
Air Flow Length of Pipe (feet)
CFM
50
100
10
1/2"
3/4"
20
3/4"
3/4"
30
3/4"
3/4"
40
1"
1"
50
1"
1"
70
1"
1"
Oil and water extractor should be at least 25 ft. from the compressor. Further if possible.
Page 3
Product Type:
AIR BELT SANDER 1/2" x 18"

CAUTIONS FOR USE:

1. This tool is intended for polishing and sanding with a rotary
movement using abrasive products of appropriate material
compositions and grits. Any other use is forbidden.
2. Only use the polishing and sanding belts as recommended by
the belt manufacturer.
3. Ensure the maximum operating speed of the belt is higher than
the rated speed of the power tool.
4. Always wear ANSI approved ear protection and safety glasses
when using this tool. Gloves and protective clothing are
recommended.
5. Personal protection and dust collection devices shall be
chosen according to the material being worked upon. Please
consult provider of such devices.
6. Release the the start/stop lever in the case of air supply loss.
7. Only use the lubricant recommended by the manufacturer.
Install drain at
each low point
150 200
3/4"
3/4" 3/4"
1" 1"
1" 1"
1" 1"
1-1/4" 1-1/4"
25 FEET OR MORE
Oil and Water
Extractor
Drain
Daily
Drain
Daily
1511176-14MA