Utilitech Pro WL160208 Manual Del Usuario página 8

OPERATION INSTRUCTIONS
CAUTION
To avoid being burned, always hold the work light by its
grip handle (A) when making adjustments.
WARNING
RISK OF FIRE. DO NOT place work light near flammable
or combustible surfaces.
ON/OFF Switch
The on/off switch (E) is at the back of the light. Press
the switch (E) toward the "I" symbol to turn the lamp on.
Press the switch (E) toward the "O" symbol to turn the
lamp off.
NOTE: Always turn the work light off before unplugging.
Adjusting The Light Direction
The lamp head (C) can be adjusted freely to the
desired angle. With one hand securely holding the
folding stand (D), use the other hand to adjust the
lamp head (C).
Extension Cords
- The maximum extension cord length recommended for this work light is 49 in. Use of extension
cords longer than 49 in. may cause a voltage drop that can dim the lights.
- Extension cords used with this work light must have an adequate American Wire Gauge (AWG) or
wire size for safe, efficient use. The smaller the gauge of the wire, the greater the capacity of the
wire (e.g. 14-gauge wire has more capacity than 16-gauge wire).
- Use an extension cord or minimum 14-gauge (AWG) 3-conductor or higher capacity wire, such as
12-gauge or 10-gauge for this work light.
- Always make sure that the prongs on the plug of the extension cord are the same number, size and
shape as those on the work light plug.
- Always be sure that the extension cord is in good electrical condition.
Storage
1. Always allow the work light to cool down completely before storing.
2. Store in a safe place, out of reach of children.
7
8
C
D
8
E
A